Installation

Whole House Generator Cost Calculator: Add Up Your Real Price

A by-hand calculator for your standby generator, with unit, install, fuel and city numbers.

Home standby generator on a pad beside a house, near the gas and electric meters

Disclosure: This post may contain affiliate links. As an Amazon Associate, we earn from qualifying purchases. This comes at no extra cost to you. Ratings reflect our own editorial evaluation.

Table of Contents

A standby generator can price at $6,000 or $25,194, depending on which guide you open.

That gap comes from what each number counts, not from the machine itself.

So this whole house generator cost calculator runs by hand: 4 lines, sourced prices and one worked example. You’ll have your own range before a dealer visits.

How Much a Whole House Generator Costs Installed

A whole house generator costs $8,000 to $16,000 installed for most U.S. home standby systems, according to a Generac cost page. That total covers the generator, other equipment, materials and installation.

Other guides land on either side of it. The HomeGuide cost guide from December 2025 averages $6,000 to $11,000, counting the unit and labor.

ProjectCostPro planning ranges, reviewed in September 2026, run far higher: $14,469 to $25,194 for a 20-22 kW natural gas job. Those ranges add contractor markup, a permit and 30 feet each of gas line and wiring, and they aren’t bids.

ProjectCostPro whole-house generator cost calculator page with its project inputs

So treat every published range as one scope, then build your own number.

Whole House Generator Cost Calculator: 4 Lines to Add Up

A whole house generator cost calculator adds 4 lines: the generator, installation, fuel and extras, then your city. Write a low and a high for each line, because a range protects you better than one number.

Line 1: Price the Generator by Home Size

Home size gives you a fast starting price. Here are the HomeGuide unit prices, before installation:

Home sizeGenerator sizeUnit price
Under 1,500 sq ft13-16 kW$3,000-$4,500
1,500-3,000 sq ft17-20 kW$4,000-$6,000
3,000-5,000 sq ft22-25 kW$4,500-$12,000

Those prices date from late 2025, so use the top of the range for a current name brand. A comparison site compiling manufacturer list prices on October 27, 2026 shows the Kohler 20RCA at $6,016 and the Generac 22 kW Guardian at $6,119.

Square footage is only a rough guide, though. ProjectCostPro says the standard rule is your largest motor load, usually the AC, plus 20-30% headroom.

Electric appliances change the answer too, so confirm your size before you trust this line.

Line 2: Add Installation

Installation adds $3,000 to $5,000 on average, the HomeGuide guide says. Use $5,000 to $12,000+ if your generator sits far from the panel and gas meter or runs over 20 kW.

Hands pulling a tape measure from a gas meter along a house wall to the generator spot

Distance is the part you can control, so walk the route before you price it. The site requirements can move the spot you pick, and the full installation process shows who does what.

Line 3: Add Fuel and Extras

Fuel and extras can change your total by thousands. HomeGuide lists the automatic transfer switch as its own cost, so keep it in unless a quote shows it’s covered:

Line itemLowHigh
Automatic transfer switch$600$2,500
New propane tank$400$1,800
Smart load manager$130$250
Cold-weather kit$130$500

Add only what your home needs. A smart load manager uses load management to let a smaller generator run more appliances, so price a smaller unit with one before you settle Line 1.

The switch alone can swing your total by $1,900, which is why the switch installation cost deserves its own quote line.

Line 4: Adjust for Your City

Your city adjusts the subtotal, because local labor and materials move the price. ProjectCostPro compares these metros with its national range:

  • Miami: 0%
  • Phoenix: +4%
  • Houston: +8%
  • Boston: +13%
  • Atlanta: +17%
  • Chicago: +18%
  • San Francisco: +25%
  • New York: +27%

Pick the closest match, then multiply. These are planning figures, so use them to set a budget, not to argue with a bid.

Example: A 2,000 Sq Ft House in Chicago

A 2,000 sq ft house on natural gas in Chicago comes to about $8,968 to $15,930 on this calculator. This hypothetical uses a 17-20 kW unit with a normal install and a short gas run:

  • Generator: $4,000 to $6,000
  • Installation: $3,000 to $5,000
  • Automatic transfer switch: $600 to $2,500
  • Subtotal: $7,600 to $13,500
  • Chicago at +18%: $8,968 to $15,930

That lands close to the published Generac range, which is a good sign the lines are complete.

Natural Gas vs Propane Cost

A propane generator costs about the same to install as natural gas unless you need a new tank. ProjectCostPro prices a new 250-500 gallon tank at about $1,471 to $2,500 extra on a 22 kW job, while the HomeGuide guide lists $400 to $1,800.

White above-ground propane tank behind a house with a standby generator in the background

Running costs split much wider. HomeGuide puts a 20 kW unit at $30 to $40 a day on natural gas and $150 to $170 on liquid propane, depending on local fuel prices.

So if a gas line reaches your house, natural gas usually wins on both counts.

Costs Online Calculators Leave Out

Online calculators can leave out utility work, old equipment and fuel. ProjectCostPro says its own estimate skips utility upgrades, propane tank rental, ongoing fuel and removing an old generator.

Watch for these too:

  • An upgraded panel or meter, which Generac says some homes need. We found no firm figure, so get it priced.
  • A bigger gas line, since ProjectCostPro says 14 kW and larger natural gas units need 1-1/4 inch pipe.
  • A crane fee of $500 to $2,000 for a roof or upper-deck mount.

Ask about each one before you compare totals.

What a Complete Quote Should Include

A complete generator quote lists the model and kW, transfer switch, electrical work, fuel connection, pad, permits and taxes as separate lines. HomeGuide advises getting at least 3 in-person estimates and a full breakdown of costs.

Hands with a pen comparing 3 printed generator installer quotes on a kitchen table

Here’s what to say:

“Please itemize the generator, transfer switch, wiring, fuel work, pad, permits and taxes, and list what’s excluded.”

Then put each bid next to your 4 lines, and any gap shows you what’s missing.

What It Costs to Run and Maintain Each Year

A whole house generator costs $200 to $650 a year to maintain, according to HomeGuide, plus $30 to $170 a day for fuel when a 20 kW unit runs. A closer look at upkeep helps you plan each service visit.

So multiply your daily fuel cost by your usual outage days. Your fuel and runtime depend on load as well.

Is a Whole House Generator Worth It?

A whole house generator is worth it for frequent or long outages, medical equipment, a well pump or working from home, ProjectCostPro says. For short, occasional outages, it points you to a portable with a manual interlock, at $4,400 to $7,700 installed.

So price what a bad outage costs you, then compare it with your Line 4 total.

Your Next Step

Your real number comes from your own 4 lines, not a national average.

This week, fill in all 4 and walk the route from your meter to the spot you want.

Then book 3 estimates and hand each dealer the same list.

Frequently Asked Questions

How much does a generator cost for a 1,500 sq ft home?

A standby generator for a home just under 1,500 sq ft comes to about $6,600 to $12,000 on this calculator at national prices. That total adds a 13-16 kW unit, installation and a transfer switch, and propane or a long run adds more.

What size generator do I need to run a 1,500 sq ft house?

A 13-16 kW generator runs a full home under 1,500 sq ft, according to the HomeGuide cost guide. Your AC and well pump matter more than floor area, so have an electrician confirm the size.

How much does a whole home generator add to the value of a home?

A whole home generator can raise home value by 5% and return up to 150%, the HomeGuide cost guide says, crediting Consumer Reports and Remodeling magazine. Treat those as best-case figures, not a promise.

Matthew Collins
Matthew Collins

I’m Matthew Collins from Tulsa, Oklahoma. After 15 years in property maintenance, I have little patience for generator hype or neglected servicing. Here at Generator Den, I write about sizing, installation, maintenance, model comparisons, and outage safety to help households plan backup power that suits their actual needs.

More about Matthew Collins →